Wallet with Power banks

Product Detailed Description

A flat wallet folded down its center, an inner panel cut to cradle a power module behind the card slots. The module sits against the backing fabric so no bulge shows when both flaps close over each other. You open the wallet, lift the module edge with a thumb, feed a cable from the side port, then fold the flaps back. On a desk or counter the wallet stays low and square, its outer face turning under light without a loose battery shifting inside. In the trade channel, a buyer reaches for this shape when a piece must store cards and charge a phone from the same fold.

• A cut channel in the backing fabric holds the module at its edges, keeping it flush against the panel
• A cable feeds from the side port so you plug in a phone without separating the module from the wallet
• Each card slot sits on a separate layer of the inner panel so you fan the cards open to read them
• Flat stitching runs along the spine keeping both halves aligned so the closed wallet rests low in a front pocket
• Card slots sit on the facing panel above the module bay, keeping the charging section clear of the outer edge